USB Blaster function overview
• support ALTERA company a full range of FPGA/CPLD device
• support ALTERA company full range of active the serial configuration device
• support ALTERA company full range enhanced configuration device
• support the AS, PS, JTAG download three patterns
, high speed, stability, internal adopts FT245R + CPLD design
• programming support 1.2 5 v voltage
• support the SignalTap II embedded logic analyzer
• support the Nios II embedded processor communication and debugging
Support the software
• the Quartus II integrated development environment
• the NIOS II IDE integrated development environment
, EDS NIOS II integrated development environment
Supported by the device
• CPLD: MAX3000, MAX7000A/B/S, MAX9000 and MAX II, etc
FPGA: Stratix, Stratix, Cyclone, the Cyclone II, II CycloneIII, 1 k, 20 k APEX and ACEX FLEX 10 k,
etc
Active the serial configuration device: EPCS1, EPCS4, EPCS16, etc
• enhanced configuration device: EPC1 and EPC4, etc
Product features
, and high-speed download plan: FT245 + CPLD + 244, ALTERA USB BLASTER download speeds
close to the original factory
Download compared to other solutions, such as 68013 or C8051F, 1 to 3 times as fast
Connected to the PC
• connect to computer with USB 2.0 interface
Connected to the target board
• through the JTAG, AS, PS plate connected with the target interface
Hardware development environment
Connected via USB Blaster "FPGA/CPLD target board" and "PC", establish a complete hardware
development environment, programming and debugging of target chip
USB Blaster state of lamp
Light, red light: power
, a green light, signal light, carries on the software download, green light
The configuration list
1. USB Blaster programmer
2. USB cable
3.10 the pin line
4. The data CD