LED Battery indicator Mobile Charger Power bank circuit board 3.7V up to 5V 2A boost

ARD009562
New product

6,64 €

Immediately available

- +

Add to compare

Free Google QRcode module

 
More info

LED Battery indicator Mobile Charger Power bank circuit board 3.7V up to 5V 2A boost

Product Features:
1.4-level LED lamp display power, not working state intelligent automatic shutdown;
2. Built-in lithium battery protection IC, over-current, overpressure, undervoltage protection;
3. Dual USB output;
4, motherboard size: Thick 8mm* width 32mm* long 69mm.
Product Basic Parameters:
Input port: MicroUSB (Andro)
Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5v1a above
Output port: USB
Output parameters: 5V1A/5V2A
Requirements for rechargeable batteries:
Available Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery, can be a single section (piece) power supply, can also be multiple sections (tablets) parallel power supply (not supported in series, not in series). (Note: Parallel increase in capacity, series is to increase the voltage, only in parallel!) )
Can parallel 2-6 knots 18650 batteries!!!
Non-battery: dry battery, battery, 1.2V rechargeable battery, NiMH battery, 3.2V Lithium Lithium Polymer battery.

 

The following points should be noted when installing products:
1, the battery to parallel, the voltage in 3.2-4.2V can work between, 18650 flat and polymer battery can be;
2, the battery is connected to the motherboard B + negative-, installed against the necessary burning motherboard;
3, the new and old batteries, model brand inconsistent batteries can not be mixed.

Write a review

LED Battery indicator Mobile Charger Power bank circuit board 3.7V up to 5V 2A boost

Write a review

 
Comments(0)

No customer reviews for the moment.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
0,00 € Total

Check out